Plastic Testing Equipment charpy impact tester

一. The product introduction:

    The Plastic Testing Equipment charpy impact tester is mainly used for the determination of impact toughness of non-metallic materials such as hard plastic, reinforced nylon, glass reinforced plastic, ceramic, cast stone and electrical insulating materials. It is an ideal test equipment for chemical industry, scientific research units, universities and colleges, and quality inspection departments.

二. The implementation of standards, Plastic Testing Equipment charpy impact tester:

        ISO179-2000 "Determination of impact strength of simply supported beams of plastics and hard materials"

        GB/T1043—2008 “Stiff Test Method for Hard Plastic Simply Supported Beams”

        JB/T8762-1998 "Plastic simply supported beam impact testing machine"

        GB/T 18743-2002 "Standard Test Method for Simply Supported Beams of Thermoplastic Pipes for Fluid Transportation" (Applicable to Pipe Parts)

三. product features of Plastic Testing Equipment charpy impact tester:

      1. High-precision intelligent controller with LCD display for intuitive and accurate data reading

      2. Using carbon fiber pendulum rod, in the impact direction, improve the rigidity of the material, and concentrate the impact mass on the centroid of the pendulum, truly vibration-free impact test, and the service life increases.

      3. Imported high-resolution digital encoder, the angle test accuracy is higher and more stable

      4. Aerodynamic principle of impact hammer and imported ball bearing, greatly reducing the friction loss caused by machinery

      5. Automatic calculation of the final result, the test data can save 12 sets of data and average

      6. Choice of Chinese and English operation interface, test results can choose J / m, KJ / m2, kg-cm / cm, ft-ib / in and other units

      7. Built-in micro printer print test data

四.  technical specifications of Plastic Testing Equipment charpy impact tester:

      1. Impact speed: 2.9m/s or 3.8M/S;

      2. Distance from pendulum center to sample center: 221mm, 380mm

      3. Pendulum angle: 150°

      4. Jaw support spacing: 40mm, 60mm, 70mm, 95mm

      5. Support blade corner radius: R=1mm

      6. Impact blade angle: 30°

      7. Impact blade fillet radius: R = 2mm ± 0.5mm